Default values of Pre-Configured Alerts on a new Trial Account

Default values of Pre-Configured Alerts on a new Trial Account

 

Notification Profile - By default only 1 Notification Profile is created, which is the email-ID of your CopperEgg Account. So, all alerts shall be sent as Email to your email-ID used with CopperEgg Account

The 2 points below are applicable to all Default Alerts

-> Automatic Clear - Automatically clear the issue if the condition is resolved.
-> Notify on Clear - Send notification when the issue is cleared.

Monitoring Probes are sent from all the STATIONS that you selected while creating the probe.  The Calculation are based upon the cumulative metric values received by all selected Stations.

Server related default Alerts

1. CPU - High

Server:CPU:Active (Minimum) >= 90% for at least 2 Min

CPU usage is more than 90% for 2 min

2. Filesystem - Almost Full

Server:Filesystem:Used (Maximum) >= 95% for at least 10 Min

Partition/Filesystem on storage/hard-disk is 95% filled for 10 min

3. Filesystem - FULL (Disabled)

Server:Filesystem:Used (Maximum) >= 99% for a tleast 10 Min

Partition/Filesystem on storage/hard-disk is 99% filled for 10 min

4. Filesystem - Medium Threshold (Disabled)

Server:Filesystem:Used (Maximum) > 80% for at least 10 Min

Partition/Filesystem on storage/hard-disk is 80% filled for 10 min

5. Load - Extremely High

Server:Load:Shortterm (Minimum) > 16 for at least 2 Min

Load on the server has gone above 16 for atleast 2 min

6. Load - High (Disabled)

Server:Load:Shortterm (Minimum) >= 5 for at least 2 Min

Load on the server has gone above 5 for atleast 2 min

7. Lost Connectivity

Server:Servernotseen for at least 10 Min

Server is unreachable. The reasons could be server is down or there is network issue.

8. Memory Use - Extremely High (Disabled)

Server:Memory:Used (Average) > 99% for at least 1 Min

Above 99% of the Primary Memory has been in use for at least 1 Min

9. Memory Use - High

Server:Memory:Used (Average) > 95% for at least 3 Min

Above 95% of the Primary Memory has been in use for atleast 3 Min

 

Probes (Website or TCP Probe) related default Alerts

 

1. Error Status Code (Disabled)

Probe:Status Code =~(contains) ^[45] for at least 1 Min

The website response contains 400-499 or 500-599 HTTP status codes, for atleast 1 min

2. Error Status Code

Probe:Status Code !~(does not contain) ^[23] for at least 3 Min

The website response does NOT contain 200-299 or 300-399 HTTP status codes, for atleast 3 min

3. Poor Health (Disabled)

Probe:Health (Maximum) < 0.5 for at least 3 Min

Health of the Probe has been less than 50% for at least 3 min. Health is calculated on basis of many factors like reach-ability, response time and HTTP Status Codes received etc. Also the values are calculated on basis on metrics received by all selected Monitoring Stations.

4. Site Down

Probe:Uptime (Maximum) < 0.33 for at least 1 Min

The Probe is down if it has responded to less than 33% of the requests sent over atleast 1 min

5. Slow Response Time (Disabled)

Probe:Response:Total Time (Minimum) >= 6000 ms for at least 3 Min

The probe takes above 6000 ms to respond for alteast 3 min.

Powered by Zendesk